81
Care and Maintenance
2
(1)Hold the fuser as shown below, and slide it out of the printer.
Safety Caution:
The fuser unit weighs approximately 3.1 kg (6.8 lbs.). Take care when handling it.
(2)Close the front cover.
3
Remove the oil supply roll:
(1)Press out on tabs to unlock the oil supply roll.
(2)Remove the oil supply roll out of the fuser.
Note:
If the paper is not jammed in the fuser unit, perform the following.
(1) Repeat steps 1 to 4 of Jam B on page 79.
(2) Skip step 4 and go to step 5.
(1)
(2)
(2)
(1)
(1)
To Next Page
Loading...
