84
Care and Maintenance
■ Jam at D
Safety Caution:
The fuser is hot. To avoid personal injury, turn off the printer and wait 10 minutes
(after opening the front cover) for the fuser to cool before touching it.
Note:
First check the exit opening for media that has jammed and folded like an accordion.
It is especially difficult to see if the media is transparency film.
1
A
(Printing face down)
(1)Open the front cover.
(2)Pull open the access door (above the plastic output tray). See if
the media is visible.
(3)Turn the large green knob on the fuser counterclockwise.
(4)Remove the media from inside the access door.
(1)
(2)
(4)
(3)
To Next Page
Loading...
