85
Care and Maintenance
Caution:
If the fuser knob will not turn, do not force it, or you may damage the fuser. Instead,
follow these steps:
a) Unlock the fuser by turning the small green thumbscrew counterclockwise.
b) Pull the fuser out. The media will probably tear.
c) Remove the oil supply roll.
d) Turn the fuser’s large green knob to release the jammed media.
e) Remove the jammed media from the fuser and the printer.
Safety Caution:
The fuser is hot. To avoid personal injury, turn off the printer and wait 10 minutes for
the fuser to cool before touching it.
Close the front cover.
1
B
(Printing face up)
(1)Open the front cover and the right side cover.
(2)Turn the fuser’s large green knob counterclockwise to release the
jammed media.
(3)Remove the jammed media from the right side of the printer.
(4)Close the front cover and the right side cover.
(3)
(1)
(2)
To Next Page
Loading...
