86
Offset
The Offset stacks each printed document by shifting from right to left as it is delivered to the
output tray.
Offset is available on printers with a supported finisher (optional) installed.
After installation, optional equipment must be recognized by the printer driver (device
settings). For further details, refer to Installing Optional Devices
on page 17.
Offset and Staple cannot be used simultaneously.
Using the Offset
1. From the application’s Print dialog box, specify the number of copies of the document to
be printed.
2. Click Properties in the Print dialog box. The Properties dialog box appears.
3. Click the Output tab in the Properties dialog box.
4. Set either Finisher (Face-down) or Finisher (Face-up) as the output destination, then
enable the Offset check box in the Finishing Options section.
5. Click OK to return to the Print dialog box, and click OK to start printing.
After the first set is delivered, the second set will be delivered offset to the side. Then the
printer delivers the third set in the same position as the first and the fourth set in the same
position as the second.
Output direction
To Next Page
Loading...
