Chapter 3 Using the Operator Panel
3-28
Press the ENTER key. A blinking cursor ( _ ) ap-
pears.
Press the or key to increase or decrease the val-
ue of the figure where the cursor is blinking. It can
be set between 1 and 999. You can use the and
keys to move the cursor right and left.
When the desired size is displayed, press the ENTER
key.
Press the MENU key. The message display returns
to Ready.
Selecting the Reduced Print
You can print with the reduced size. This menu is used to set
the source paper size and the paper size to use after reduc-
tion.
Printed results when making reductions differ from equiva-
lent size printing. Sometimes the line width of characters
may not be consistent or lines may appear in figures or im-
age patterns.
Bring up the Zoom menu. The following display will appear.
Source size indicator...
This is the paper size before reduction.
This must be the same as the paper size set for print data
from the computer.
Target size indicator...This is the paper size after reduction.
This must be the same as the paper size set for the paper cas-
sette.
The message display will show the messages given in the fol-
lowing table.
Press the MENU key.
Press the or key repeatedly until Page Set >
appears.
Press the key.
Press the or key repeatedly until >Zoom ap-
pears.
>Copies
001
NOTE
>Zoom
[CS]→[CS]
5
6
7
8
Target size indicator
Source size indicator
Source size indicator Target size indicator
[CS]
Current cassette size
[CS]
[CS]98%
[LG]
Legal size (8-1/2 × 14 inches)
[LG]
[LG]98%
[LT]
Letter size (8-1/2 × 11 inches)
[LT]
[A4]
[LT]98%
[LD]
Ledger size
(12 × 15-1/2 inches)
[LD]
[LD]98%
[ST] [ST]
[O2] [O2]
[FO] [FO]
[A5]
(14.8 × 21 cm)
[A5]
[A5]98%
[B5]
(18.2
×
25.7 cm)
[B5]
[A5]
[B5]98%
[A4]
(21
×
29.7 cm)
[A4]
[LT]
[B5]
[A5]
[A4]98%
[B4]
(25.7
×
36.4 cm)
[B4]
[B5]
[A4]
[B4]98%
[A3]
(29.7 × 42cm)
[A3]
[A4]
[B4]
[A3]98%
Table 3-9
Page Set >
>Zoom
[CS]→[CS]
1
2
3
4
To Next Page
Loading...
Need help?
General
Weight and Dimensions
