2GL/2FV/2FW
1-6-17
(3) Detaching and refitting the engine/high voltage PWB and power source PWB
<Procedure>
1. Remove the developer unit and drum unit.
See page 1-6-6.
2. Remove the paper cassette.
3. Remove the outer covers. See page 1-6-2.
4. Remove the six connectors.
* When seating the engine/high voltage PWB,
ensure that the developer bias terminal
spring is correctly in contact with the devel-
oping bias terminal (TB1) on the engine/high
voltage PWB.
Figure 1-6-23
Connector
Connectors
Developing bias
terminal spring
Engine/high
voltage PWB
Developing
bias terminal (TB1)
To Next Page
Loading...
