Using the Operation Panel
2-96 ADVANCED OPERATION GUIDE
Staple Error Detection Setting
This setting controls whether or not message Add staples appears
when the finisher units runs out of staples during output of a stabled job.
1
Press [MENU].
2
Press U or V repeatedly until Others >
appears.
3
Press Z.
4
Press U or V repeatedly until >
Finishing Error > appears.
5
Press Z.
6
Press U or V repeatedly until >>Staple
appears.
7
Press [OK]. A blinking question mark (?)
appears.
8
Press U or V to change Off to On.
9
Press [OK].
10
To exit the menu selection, press [MENU].
On
Message is displayed and printing pauses.
Printing resumes automatically when staples are
replenished.
Off
Message is displayed, but printing continues without
stapling.
Others >
>Finishing >
Error
>>Staple
Off
>>Staple
? Off
To Next Page
Loading...
