Using the Operation Panel
2-22 ADVANCED OPERATION GUIDE
6 Network Status
This shows the IP address, Subnet Mask address, and Default
Gateway address for the network interface.
7Emulation
This shows all available emulations of the printer. The printer is shipped
from the factory with PCL 6 emulation selected as the default.
8 Error Log
This shows the last three instances of the following types of errors,
listing them in the order of their occurrence:
• KPDL (PostScript) errors
• Memory card errors
• Memory card, hard disk, RAM disk errors
The most recent error is displayed on the top line of the Error Log. For
error remedies, refer to Maintenance Messages on page 4-7 in the
Operation Guide. Error information is cleared when the printer’s power
is turned off.
9 Toner Gauge
This shows the approximate level of remaining toner. When the value
is 100, the toner container is full.
NOTE: If you are not using an original Kyocera toner container, the
amount of toner remaining does not appear, and instead the following
message appears.
We recommend the use of our own brand supplies.
We will not be liable for any damage caused by the use
of third party supplies in this machine.
10 Interface Information
This information shows the default font and the default emulation for all
interfaces installed in the printer.
11 KIR Test Pattern
KIR is the Kyocera’s original smoothing function. This test pattern
shows the effect of the KIR (Kyocera Image Refinement) system.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
