Using the Operation Panel
2-44 ADVANCED OPERATION GUIDE
6
Press Z. The message display changes to
that shown below. If >Print KPDL Errs
is displayed when the KPDL (AUTO)
emulation is selected, press U or V to
change it.
7
Press [OK]. A blinking question mark (?)
appears.
8
Select On using U or V.
9
Press [OK].
10
Press [MENU]. The message display returns to Ready.
KC-GL Pen Width
The KC-GL emulation mode enables you to set the pen widths in dots, for
pen numbers 1 to 8, and the KC-GL page size.
1
Press [MENU].
2
Press U or V repeatedly until Emulation
appears on the message display.
3
If the current emulation is other than KC-
GL, press [OK]. A blinking question mark
(?) appears.
4
Press U or V repeatedly until KC-GL
appears.
5
Press [OK].
6
Press Z to move to the >KC-GL Pen
Width submenu.
7
Press Z.
>Print KPDL Errs
Off
>Print KPDL Errs
?Off
>Print KPDL Errs
?On
Emulation
PCL 6
Emulation
?PCL 6
Emulation
?KC-GL
Emulation
KC-GL
>KC-GL >
Pen Width
>>Pen(1) Width
01 dot(s)
To Next Page
Loading...
