Using the Operation Panel
ADVANCED OPERATION GUIDE 2-63
6
Press [OK]. Processing appears and the
reading of data from the memory card
starts.
7
Press [MENU] to return to Ready.
Reading Data
Data stored on a memory card can be read. To read data on a memory
card, proceed as follows.
1
Press [MENU].
2
Press U or V repeatedly until Memory
Card > appears.
3
Press Z.
4
Press U or V repeatedly until >Read Data
appears. The data name also appears.
5
Press [OK]. A blinking question mark (?)
appears before the data name.
6
Press U or V to display the desired data name.
7
Press [OK]. Processing appears and the reading of data from the
memory card starts.
Writing Data
Data can be written to a memory card until no space is left for storing.
When writing to a memory card, a name is assigned to the file
automatically. You can use the procedure explained later in this section to
print a list of data names for confirmation.
To write data to a memory card, proceed as follows.
First check that the memory card is properly formatted. Otherwise, the
>Write Data message to be explained below will not be shown on the
message display.
If the memory card inserted in the memory card slot is not formatted, the
>Format will automatically appear on the display. Refer to Formatting on
page 2-66.
>Read Fonts
Processing
Memory Card >
>Read Data
DataS001
>Read Data
?DataS001
To Next Page
Loading...
