System Maintenance Reference
92
Firmware Updating
Do not turn off the main power of the machine during the firmware updating. If doing
so, the engine board or controller board may be damaged.
Checking the Machine Firmware Version
1. Turn the machine on.
2. Press "User/Tools" key and select "Report Print" with the "Up" or "Down" key.
3. Press "OK" and select "Maintenance Page" with the "Up" or "Down" key.
4. Press "OK" to display the "Firmware version (Controller)" and "Engine FW version"
Updating the Controller Firmware
Using the following procedure to update the controller firmware. Be sure to print the
configuration page both before and after the update. Comparing pre- and post-update
configuration pages allows you to check whether or not the update was successful.
Follow the procedure carefully, and note that it will vary in parts depending on which version
of the firmware is currently installed.
Preparation
1. Download the firmware file on you PC.
2. Unzip the firmware file.
The firmware file contains the manual folder and other updating applications as
show above.
To Next Page
Loading...
