Kyocera FS-C1020MFP - Page 154

Appendix: SP Mode Tables
39
Fax Maintenance
the telephone line.
[0Km (Default)/ 1.8Km/ 3.6Km/ 7.2Km]
Training Retries
This sets the number of training retries to be
repeated before automatic fallback.
[1 Time/ 2 Times (Default)/ 3 Times/ 4 Times]
Protocol
Definition
Encoding
Sets the compression method for Tx/Rx.
[MMR+MR+MH (Default)/ MR+MH/ MH]
T0 Timer
Timeout for response from the called station in
automatic sending mode
[35 Sec/ 45 Sec/ 55 Sec (Default)/ 60 Sec/ 90 Sec/
140 Sec]
T1 Timer
Set the time length for the T1 timer.
[40 Sec (Default)/ 50 Sec]
Protocol
Definition Timer
T4 Timer
Set the time length for the T4 timer.
[3 Sec (Default/ 4.5 Sec]
Silence
Detection Time
Silence (No tone) detection time (Rx mode : FAX/
TAD Only)
After the line is connected via the external
telephone, the machine can detect silence (no
tone) for the time length specified by this setting.
[30 sec (Default)]
CNG Tone
Detection Time
CNG tone detection time ( RX mode : FAX / TEL,
FAX / TAD Only)
After the line is connected via the external
telephone, the machine can detect a CNG signal
for the time length specified by this setting.
[5 Sec (Default)/ 10 Sec]
RX Settings
CNG Cycles
Number of CNG cycles to be detected
This setting is only effective for FAX/TAD mode.
[1.5 Cycle (Default)/ 2.0 Cycle]