Kyocera FS-C1020MFP - Page 80

Replacement and Adjustment
70
6. Exit the serial number input display, and then enter "Engine Maintenance" again.
7. Select "Destination", and then select a destination.
8. Select "Model", and then select a model.
9. Select "PnP Name", and then select a plug and play name.
10. Select "LSU Adjustment", and then input the LSU (laser optics housing unit) setting
values.
11. Turn off the machine.
12. Turn on the machine with the front cover open.
13. Enter "Engine Maintenance" in the "Maintenance Mode Menu" again.
14. Close the front cover.
15. Select "Trans. Belt Adjust", and then execute "Trans. Belt Adjust" to adjust the ITB
(Image Transfer Belt) unit.
16. Select "Fuser SC Detect", and then select "ON" or "OFF" for the consecutive fusing jam
detection.
 The default setting is "OFF". Select "ON" only if the customer wants to use this
feature.
17. Select "Registration", and then adjust the registration for each direction (vertical and
horizontal direction) and tray if necessary.
18. Select "2nd Transfer Fuser Temp", and then adjust the transfer roller bias and the
temperature reduction of the fusing unit for each paper type and for the front and back
sides. The default settings for normal operation are all '0'.
19. Exit "Engine Maintenance".