Using the Operation Panel
2-26
For example, to change baud rate from 9600 to 115200, display
the baud rate menu following the above procedure. When the
display shows baud rate, 9600 (bps), press [OK]. A blinking
question mark (?) appears.
7
Press or to scroll through values. When 115200 is displayed, press [OK]. Press [Menu] to
exit the menu selection.
NOTE: Some computers may not be able to handle a baud rate of 115200 bps. If you set the baud
rate to 115200 and encounter communication problems, select a lower baud rate.
Changing Network Interface Parameters
This printer supports TCP/IP, NetWare and AppleTalk protocols. In addition, you can install the
optional network interface card in the option interface slot.
Using the operation panel, you can:
• Activate or deactivate TCP/IP, NetWare, and AppleTalk
• Activate or deactivate DHCP
• Enter IP address, subnet mask address, and default gateway address
• Determine whether to print a network status page when the printer is turned on
1
Press [Menu].
2
Press or repeatedly until Interface > appears.
3
If the current interface is other than Network, press [OK]. A
blinking question mark (?) appears.
If the optional network interface card is installed in the printer,
Option will be displayed. The setting procedure is basically the
same even in this case.
4
Press or repeatedly until Network appears.
5
Press [OK] again.
>Baud Rate
? 9600
Interface >
? Parallel
Interface >
? Network
To Next Page
Loading...
Need help?
General