Using the Operation Panel
2-35
Character Pitch for Courier/Letter Gothic
You can set the character pitch for fixed fonts when the default font is Courier or Letter Gothic.
1
Press [Menu].
2
Press or repeatedly until Font > appears.
3
Press . Press or until >Font Select > appears.
4
Make sure that Internal is displayed and press .
5
Press or repeatedly until >>Pitch appears.
6
Press [OK]. A blinking cursor (_) appears.
7
Press or to increase or decrease the value at the blinking cursor. The character pitch can be
set between 0.44 and 99.99 characters per inch, in 0.01 character-per-inch increments. Use or
to move the cursor right and left.
8
When the desired size is displayed, press [OK].
9
Press [Menu]. The display returns to Ready.
Setting the Code Set
You can change the character code set. Available character code sets vary depending on the
current font. (The default is IBM PC-8.)
1
Press [Menu].
2
Press or repeatedly until Font > appears.
3
Press .
4
Press or repeatedly until >Code Set appears.
5
Press [OK]. A blinking question mark (?) appears.
Font >
>Font Select >
Internal
>>Pitch
10.00 cpi
>>Pitch
10.00
cpi
Font >
>Code Set
IBM PC-8
>Code Set
?IBM PC-8
To Next Page
Loading...
Need help?
General