3-14 Handling Paper
5 Align the paper against the left side of the paper cassette.
IMPORTANT Before loading the paper, be sure that it is not curled or
folded. Paper that is curled or folded may cause paper jams.
Ensure that the loaded paper is not higher than the level indicator (see
illustration below).
When loading the paper, make sure that the side that was closest to
the package seal is facing up.
The paper length and width guides must be adjusted to the paper
size. Loading the paper without adjusting these guides may cause
skewed feeding and paper jams.
Make sure that the paper length and width guides are in contact with
the paper. If there is a gap, readjust the guides.
6 Insert the appropriate paper size card in the slot to indicate the size
of the paper.
7 Gently push the paper cassette back in.
8 On the operation panel, set the type of paper (plain, recycled, etc.)
that is loaded in the paper cassette. Refer to Paper Settings on page
4-46.
Note Paper sizes are indicated on the paper cassettes as
shown.
To change between inch sizes and metric sizes (A, B sizes), follow
the steps below to change the setting of the size switch.
1 Grasp the paper width adjustment knob and move the paper
width guides to a position other than that of the size of the
paper.
2 Turn size switch A 90°.
3 Move size lever B up (C) or down (I).
C: Metric sizes (centimeters) (A, B sizes)
I: Inch sizes
4 Turn the size switch 90° to lock it.
Note If the machine will not be used for a prolonged period,
protect the paper from humidity by removing it from the paper
cassettes and sealing it in its original packaging.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
