Using the Operation Panel 4-21
If you selected a file, there are 4 Detail screens. Press Y or Z to
move between the screens.
If the entire name shown as the File Name or Folder Name will
not fit on one line, pressing [Detail] ([Right Select]) changes to a
3-line name display. If the name is 3 or more lines long, you can scroll
up or down by pressing U or V.
Pressing [OK] while file or folder details are displayed returns you to
the USB Memory menu.
Remove Memory (Removing the USB memory)
Allows you to remove a USB memory device.
IMPORTANT If the correct procedure is not followed to remove a
USB memory device, the data may be corrupted or the device may be
damaged.
1 In the USB Memory menu, press U or V to select Remove Memory.
2 Press [OK]. The printer is now ready for the USB memory to be
removed and the Mode Selection menu screen appears.
IMPORTANT If the screen on the left appears, the USB memory is
still being used. Wait until the relevant job (e.g. printing from the USB
memory) has ended and then repeat the Remove Memory procedure.