Kyocera FS FS-1300D User Manual

5-4 Troubleshooting
Faint or blurred printing Check the toner container and if necessary replace. Refer to Toner
Container Replacement on page 4-2.
Clean the charger wire. Refer to Cleaning the Printer on page 4-6.
Gray background Check the toner container and if necessary replace. Refer to Toner
Container Replacement on page 4-2.
Check the process unit and drum unit are installed correctly. Refer to
Cleaning the Printer on page 4-6.
Dirt on the top edge or back of the
paper
If the problem is not solved even after printing several pages, c
lean
the registration roller. Refer to
Cleaning the Printer on page 4-6.
If the problem is not solved after cleaning,
call for service.
Printing incomplete or out of position Check that the printing settings are correct in the application software
and the printer driver.
Check whether the problem is being caused by a PRESCRIBE
command error. If the problem occurs only with a specific file or
program, the most likely cause is an error in a parameter to a
command or command syntax.
Printed Results Corrective Action

Kyocera FS FS-1300D Specifications

General

Print Technology	Laser
Resolution	1200 x 1200 dpi
Connectivity	USB 2.0
Warm-up Time	15 seconds
Time to First Page	6 seconds
Output Capacity	250 sheets
Processor Frequency	360 MHz
First Print Out Time	6 seconds
Dimensions	375 x 393 x 250 mm
Weight	10.5 kg
Print Speed	28 ppm
Paper Capacity	250 sheets
Memory	32 MB
Supported Operating Systems	Windows, Mac, Linux