Troubleshooting 5-7
Maintenance Indication
The table below shows the indicator combinations when user
intervention is required. It is assumed that the printer is online and is
processing data.
Indicator Meaning Remedy
There is no paper in the cassette,
MP tray, or Manual Feed.
Load paper into the paper source.
The cassette is not inserted
properly.
Insert the cassette fully into the printer.
The top cover is open. Close the cover.
There is no cassette in the paper
feeder or the cassette specified as
a paper supply is not inserted
properly.
Re-insert the cassette and then try
printing again.
The process unit or toner
container is not installed.
Install the process unit or toner
container.
The cassette does not contain the
paper specified by the printer
driver.
Load the paper into the cassette (#[1 or
2]) and then restart printing. You can
change the paper source by pressing
the [GO].
The paper sizes do not match. If the paper size in the paper source
differs from the paper size and type
specified by the printer driver, you can
print by supplying paper from the MP
tray or Manual Feed. Load the correct
paper size and type into the MP tray or
Manual Feed and press [GO] to begin
printing.
If you want to supply paper from a
source other than the MP tray or
Manual Feed, you can change the
paper source by pressing [GO].
If the paper fed from the MP tray or
Manual Feed is a different size from the
specified paper size, a paper jam will
occur.
A paper jam occurred during
printing.
Open the printer cover and remove the
jammed paper.
To Next Page
Loading...
Need help?
General
