Kyocera FS FS-1300D User Manual

Option 6-7
Network Interface Card (IB-23)
The network interface card supports TCP/IP, IPX/SPX, NetBEUI and
AppleTalk protocols, so that the printer can be used on network
environments including Windows, Macintosh, UNIX, NetWare, etc.
The network interface card must be installed in the option interface slot
that is located at the back of the printer.
1 Turn off the printer and disconnect the power cord and printer cable.
2 Open the rear cover.
3 Remove the optional interface slot cover.
4 Insert the Network Interface Card and secure it with the screws
removed in step 3.
5 Close the rear cover, and connect the printer cable.
6 Connect the power cord, and turn on the printer.
7 Configure the network address from Quick Setup. For more
information, refer to Operation Guide of the network card.

Kyocera FS FS-1300D Specifications

General

Print Technology	Laser
Resolution	1200 x 1200 dpi
Connectivity	USB 2.0
Warm-up Time	15 seconds
Time to First Page	6 seconds
Output Capacity	250 sheets
Processor Frequency	360 MHz
First Print Out Time	6 seconds
Dimensions	375 x 393 x 250 mm
Weight	10.5 kg
Print Speed	28 ppm
Paper Capacity	250 sheets
Memory	32 MB
Supported Operating Systems	Windows, Mac, Linux