iTag
Specification/Setup/Operation
Copyright © 2005~2007 Kyocera Mita America, Inc Version 8.0
Scan To PC
The only difference to Scan To PC is how you enter the information into the MFP. You still need the Scan
File Utility to scan from a Kyocera MFP.
To configure Scan To PC open Device Manager by Clicking the Start Button - > Kyocera -> Device Manager
-> KYOcapture Device Manager.
1. Highlight the desired device, in the example below I highlighted the LAB-KM5035.
All Rights Reserved. Page 84
To Next Page
Loading...
Need help?
General
