Get Started 2
Set Up Your Phone
You must first install and charge the battery to begin setting up your phone.
1. Install the battery.
Insert the battery into the battery compartment, making sure the connectors align
( ). Gently press down to secure the battery ( ).
Position the back cover over the battery compartment, making sure the locking tabs
align. Gently slide the cover upward with your thumbs until you hear a slight click
( ).
Slide the battery cover release latch to the locked position ( ).
2. Charge your battery.
Plug the USB connector into the charger/accessory jack on the lower left side of your
phone.
Plug the AC adapter into an electrical outlet.
Note: Your phone‘s battery should have enough charge for your phone to turn on and find a
signal, set up your voicemail, and make a call. You should fully charge your battery as
soon as possible.
3. Press to turn the phone on.
If your phone is activated, it will search for Sprint service and enter standby mode.
If your phone is not yet activated, see Activate Your Phone for more information.
Activate Your Phone
Depending on your account or how and where you purchased your phone, it may be ready to
use or you may need to activate it on your Sprint account.
● If you purchased your phone at a Sprint Store, it is probably activated and ready to use.
To Next Page
Loading...
Need help?
General
