3-1
3 Basic Operation
This chapter explains the following operations.
• Basic Copying Procedure
• Zoom Copying
• Duplex Copying
• Collated Copying
• Combined Copying
• Interrupt Copying
•Low Power Mode
• Auto Sleep
Basic Copying Procedure
1
Turn the main power switch on ( | ). At the end of
warm-up, the Start indicator lights up green.
2
Set the original onto the platen. Be sure to set the
original by aligning it with the left rear corner of the
platen along the original size indicator plates.
Note For the method of setting originals in the optional document processor, see Loading Originals in
the Document Processor on page 2-11.
3
Select the paper size. If Auto is lit on the message display, the paper of the same size as the
original is automatically selected.
To change the paper size, press the Paper Selection key to select the desired paper source.
4
Press the image quality Selection key to light up the image quality mode indicator.
See the table below for image quality to choose.
To Next Page
Loading...
