Kyocera TASKalfa 220 - Split Copying; Two-Sided to One-Sided; Book to One-Sided

Basic Operation
3-8
Split Copying
Copy books, magazines, etc. with two facing pages of an open-faced original onto separate sheets
of paper.
Two-sided to One-sided
Copies each side of a two-sided original onto two
individual sheets. The optional document processor
is required.
Book to One-sided
Produces a 1-sided copy of a 2-sided or open book
original.
The procedure for using two-sided/duplex copying
is explained below.
1
Place the originals on the platen.
2
Press [Split], select the type of original, and select or to light up the
corresponding display.
3
Press Start to start scanning.
If the originals have been set in the optional document processor, copying starts automatically.
If the original has been set on the platen, a message prompting replacement of the original is
displayed. In this case, proceed to the next step.
4
Replace the original and press the Start key. Scanning of the original is performed.
5
After scanning all originals, press the OK key to start copying.
Original Copy
2
1
1
2
Original Copy
2
1
21