Kyocera TASKalfa 2200 - Entering Symbols

10-5
Appendix > Character Entry Method
Entering Symbols
Symbols can be entered.
1 Press the [#] key. Displays the symbol list.
2 Press the [▲ (<)] or [▼ (>)] key to move the cursor and select the symbol to be entered.
d e f D E F 3 (Repeats from the first character on the left)
3 (During number entry)
g h i G H I 4 (Repeats from the first character on the left)
4 (During number entry)
j k l J K L 5 (Repeats from the first character on the left)
5 (During number entry)
m n o M N O 6 (Repeats from the first character on the left)
6 (During number entry)
p q r s P Q R S 7 (Repeats from the first character on the left)
7 (During number entry)
t u v T U V 8 (Repeats from the first character on the left)
8 (During number entry)
w x y z W X Y Z 9 (Repeats from the first character on the left)
9 (During number entry)
. , - _ ‘ ! ? (space) 0 (Repeats from the first character on the left)
0 (During number entry)
Press to change the character in the cursor position between upper case and lower case.
"*" or "." (During number entry)
!"#$%&'()*+,-./:;Displays the
symbol list. For
details, refer to
Entering Symbols
on page 10-5.
<=>?@[ \ ] ^_ ` { | } ~
# (During number entry)
* Depending on the functions, there are symbols that cannot be entered.
Keys Characters (Each press of a key changes the character in the order from left to right.)
Symbols
!"#$%&'()*+,-./:;
Symbols
!"#$%&'()*+,-./:;