2JZ/2JX/2JV/2H7-1
2-3-47
YC14 1 COV FAN1 REM O 0/24 V DC PCFM1: On/Off
Connected
to the paper
conveying
fan motor 1/
2, left cover
1 switch,
duplex
switch,
duplex
motor and
JAM detec-
tion sensor
(25/25, 30/
30 ppm
model)
2 +24V2 O 24 V DC 24 V DC power to PCFM1
3 COV FAN2 REM O 0/24 V DC PCFM2: On/Off
4 +24V2 O 24 V DC 24 V DC power to PCFM2
5 DU OPEN I 0/3.3 V DC LC1SW: On/Off
6 GND - - Ground
7 GND - - Ground
8 DU JAM I 0/3.3 V DC DUSW: On/Off
9 +5V1 O 5 V DC 5 V DC power to DUSW
10 DU AN O 0/24 V DC (pulse) DUM drive control signal
11 DU BN O 0/24 V DC (pulse) DUM drive control signal
12 DU AP O 0/24 V DC (pulse) DUM drive control signal
13 DU BP O 0/24 V DC (pulse) DUM drive control signal
14 GND - - Ground
15 BELT JAM I 0/3.3 V DC JDS: On/Off
16 +5V1 O 5 V DC 24 V DC power to JDS
YC15 1 LSU SOL DR O 0/24 V DC LSUCSOL: On/Off
Connected
to the LSU
cleaning
solenoid
(40/40, 50/
40 ppm
model)
2 +24V2 O 24 V DC 24 V DC power to LSUCSOL
YC15 1 NC - - Not used
Connected
to the feed-
shift switch,
JAM LED
PWB 1/2
and loop fan
motor (25/
25, 30/30
ppm model)
2 NC - - Not used
3 GND - - Ground
4 DU EMTER JAM I 0/3.3 V DC FSSW: On/Off
5 +5V1 O 5 V DC 5 V DC power to FSSW
6 +5V1 O 5 V DC 5 V DC power to JLEDPWB2
7 JAM2 LED O 0/5 V DC (pulse) LED emitter signal
8 +5V1 O 5 V DC 5 V DC power to JLEDPWB1
9 JAM1 LED O 0/5 V DC (pulse) LED emitter signal
10 SENSOR FAN O 0/24 V DC LFM: On/Off
11 +24V2 O 24 V DC 24 V DC power to LFM
Connector Pin No. Signal I/O Voltage Description
To Next Page
Loading...
