Basic Operation
3-24
Send to Folder (Folder Path Entry)
Stores a scanned original image file in the specified shared folder of any PC.
Stores a scanned original image in a folder of an FTP server.
1 Press the Send key.
Displays the screen for sending.
2 Place the originals on the platen.
3 Press [Folder Path Entry] and then [SMB] or [FTP].
NOTE:
• Refer to Creating a Shared Folder on page 3-31 for details on how to share a folder.
• Be sure that SMB Protocol or FTP in the Command Center RX is On. For details, refer to the Command
Center RX User Guide.
NOTE: If the touch panel is turned off, press the
Energy Saver key or the Power key and wait for the
machine to warm up.
NOTE: Depending on the settings, the address
book screen may appear. In this event, press
[Cancel] to display the screen for sending.
NOTE: Destinations can be specified using the
Address Book or the One Touch Keys. For details,
refer to Specifying Destination on page 3-39.
To Next Page
Loading...
