Sending Functions
6-38
FTP Encrypted TX
This allows you to encrypt documents when you send them. If you select [On] in this option, you can then select
the encryption method in the basic send screen.
Use the procedure below to scan and send originals as encrypted files.
1 Press the Send Key.
2 Place the originals in the document processor or on
the platen.
3 Press [Advanced Setup], [ ], and then [FTP
Encrypted TX].
4 Press [On].
5 Press [OK].
NOTE: You can only change the settings by logging
in with administrator privileges.
The login user name and login password are both
set to "2500" in the factory default state.
Click Settings -> Advanced -> Secure Protocols in
the Command Center RX. Be sure that SSL of
Secure Protocol Settings is On and one or more
effective encryption are selected in Clientside
Settings. For details, refer to the Command Center
RX User Guide.
To Next Page
Loading...
