Kyocera TASKalfa 4012i - Page 109

2-43
Installing and Setting up the Machine > Quick Setup Wizard
1
Display the screen.
[System Menu/Counter] key > [Quick Setup Wizard]
2
Select a function.
3
Configure the settings.
Start the wizard. Follow the instructions on the screen to configure settings.
Network Setup Configures network settings.
1. Network Network Selection
Wi-Fi
*7
DHCP
*8
IP Address
*9
Subnet Mask
*9
Default Gateway
*9
*1 This is displayed when the option of two FAX Kits has been installed.
*2 Inch version only.
*3 DRD reception mode is available for some countries.
*4 This setting does not appear in some regions.
*5 This function is not displayed when the optional 1,000-Sheet Finisher is installed.
*6 This function is displayed when [Weekly Timer] is set to [On].
*7 This function is displayed when [Network Selection] is set to [Wi-Fi].
*8 This function is displayed when [Network Selection] is set to [Wired Network].
*9 This function is displayed when [DHCP] is set to [Off].
NOTE
If the user authentication screen appears, enter your login user name and login password and select [Login].
The factory default login user name and login password are set as shown below.
NOTE
If you experience difficulty configuring the settings, refer to the following:
Help Screen (page 2-25)
Control Description
End Exits the wizard. Settings configured so far are applied.
Previous Returns to the previous item.
Skip Advances to the next item without setting the current item.
Next Advances to the next screen.
Back Returns to the previous screen.
Complete Register the settings and exit the wizard.
Model Name Login User Name Login Password
3212i 3200 3200
4012i 4000 4000