Kyocera TASKalfa 4012i - Page 413

8-57
Setup and Registration (System Menu) > System Menu
Security Settings
[System Menu/Counter] key > [System/Network] > [Network] > [Security Settings]
VNC (RFB) This is set when starting up a VNC Viewer (E.g. RealVNC) to use the Remote
Operation.
*1
The default port number is 9062.
Value: Off, On
Wi-Fi Direct Set whether to enable this function for each network.
Value: Disable, Enable
Wi-Fi
Wired Network
VNC (RFB) over SSL This is set when starting up a VNC Viewer (E.g. RealVNC) to use Remote Operation
protected by SSL.
*1, *2
The default port number is 9063.
Value: Off, On
NOTE
When selecting [On], it also requires a certificate for SSL. The default certificate is the
self-certificate of the machine.
Wi-Fi Direct Set whether to enable this function for each network.
Value: Disable, Enable
Wi-Fi
Wired Network
Enhanced VNC over SSL This is set when starting up Command Center RX to use Remote Operation protected
by SSL.
*1, *2
The default port number is 9061.
Value: Off, On
NOTE
• The default setting is [On].
• When selecting [On], it also requires a certificate for SSL. The default certificate is
the self-certificate of the machine.
Wi-Fi Direct Set whether to enable this function for each network.
Value: Disable, Enable
Wi-Fi
Wired Network
*1 The setting will be changed after restarting the device or network.
*2 Set "SSL" to [On] in Security Settings.
Security Settings
(page 8-57)
IMPORTANT
Depending on the protocol, there are models where you need to restart the network or turn the machine OFF
and then ON after changing the setting.
Item Description
SSL Select whether to use SSL for communication.
Value: Off, On
Item Description