KYORITSU 6050 - Page 4

― 2 ―
DANGER
● Thisinstrumentcorresponds toL-PE: 230V+10%-15%50Hz. (for
someofranges;L-L:400V+10%-15%50Hz)
Besuretouseitwithinthisratedvoltage.
● Whenconductingtestsdonottouchanyexposedmetalwork
associatedwiththeinstallation.Suchmetalworkmaybecomelive
forthedurationofthetest.
● Whentesting,alwaysbesuretokeepyourfingersbehindthe
safetybarriersonthetestleads.
● Forsafetyreasonsonlyuseaccessories(testleads,probes,
cases,etc)designedtobeusedwiththisinstrumentand
recommendedbyKYORITSU. Theuseofotheraccessoriesis
prohibitedastheyareunlikelytohavethecorrectsafetyfeatures.
WARNING
●
Never open the instrument case
-(exceptforbatteryreplacement
andinthiscasedisconnectallleadsfirst)becausedangerous
voltagesare present. Only fully trainedand competent electrical
engineersshouldopenthe case.Ifafaultdevelops,returnthe
instrumenttoyourdistributorforinspectionandrepair.
● Iftheoverheatsymbolappearsonthedisplay( )disconnectthe
testleadfromthecircuitandallowtocooldown.
● Ifabnormalconditionsofanysortarenoted(suchasafaulty
display,unexpectedreadings,brokencase,crackedtestleads,
etc)donotusethetesterandreturnittoyourdistributorforrepair.
● Neverattempttousetheinstrumentiftheinstrumentoryourhand
iswet.
● Donotrotatefunctionswitchwhentestbuttonisdepressed.