KYORITSU KEW 2003A - Other Functions; Sleep Function

 21 
7. Other Functions
7-1 SleepFunction
NOTE
The instrument consumes small amount of current in the Sleep
(power-down)mode.MakesuretoturntheFunctionSelectorswitch
tothe"OFF"position,whentheinstrumentisnotinuse.
Thisisafunctiontopreventtheinstrumentfrombeingleftpowered
on in order to conserve battery life. This function causes the
instrument to switch to the Sleep (powered-down) mode about 10
minutesafterthelastswitchorbuttonoperation.
To exit the Sleep mode, press any button or turn the Function
Selectorswitchbackto"OFF",thentoanyotherposition.
［ HowtodisabletheSleepfunction ］
Powering the instrument on with the Data Hold button pressed
disables the Sleep function. "P.OFF" is shown on the display for
about3secondstoindicatethis.
To enable the Sleep function, turn the Function Selector switch
backto"OFF",thentoanyotherposition.
NOTE
◇ The Sleep function is disabled while the output plug is
inserted into the OUTPUT terminal. When the output plug is
disconnectedfromtheterminal,theSleepfunctionisenabledin
about10minutes.