Page | 15Wireless Essential Weather Station
Sensor Search | Sensor ID
Each of your sensors has an individual ID number, located on its bar code.
This sensor ID is visible on your station by pressing the SENSOR button.
View ID numbers:
• Press and release the SENSOR button to view your station and
sensor ID numbers. All other information will disappear temporarily.
Search for all sensors:
• While viewing sensor ID, hold the SENSOR button for 3 seconds to search for your sensor.
• The station will search for your sensor ID numbers on the station.
Note: Add-on sensor ID’s will only show in the La Crosse View™ app.
• The sensor reception icon will flash for each sensor while searching.
• The sensor reception icon will be solid when sensor signal is acquired.
• Allow up to 3 minutes to receive sensor signal.
Delete Your Sensor ID
In the rare event you need to replace your sensor, you will first need to
delete the old sensor ID from your station.
1. Remove batteries from your old sensor.
2. Press and release the SENSOR button to view your sensor ID number.
3. While viewing your sensor ID, hold the MINUS button for 5 seconds
to delete your old sensor ID. Dashes will show for the ID number.
4. Your station will search for a new sensor.
5. Install batteries in your new sensor and allow up to three minutes for
your new sensor readings and ID to appear on your station.
6. Press the TX button (under the battery cover) to send a signal immediately.
TX
F/C
View Sensor ID Number
Deleted Sensor ID Number
To Next Page
Loading...
Need help?
General
