• TERMINAL BOARD M4 (Inputs 10, 11, 12)
The operation of the closing safety sensor EC1 must be enabled by dip-switch 1 of S3 = OFF.
If during closing it detects the presence of an obstacle, the door stops and reopens.
If during pause it detects the presence of an obstacle, the door remains open.
11 = Input Common.
12 = Input of opening safety sensor E.O.1, N.C. contact.
The operation of the opening safety sensor E.O.1 must be enabled by dip-switch 2 of S3 = OFF.
The door opens at slow speed if the sensor detects an obstacle during opening.
The door stops 200 mm from the end of the opening if the opening safety sensor is actived.
10 = Input of closing safety sensor E.C.1; N.C. contact.
16 = STOP input. Input contact logic state can be set by dip switch 6 of S2.
Dip
switch 7 of S1=OFF: stop command to stop door motion.
Dip switch 7 of S1=ON: switch for day / night function selection.
If the input has the contact open, the door works in day mode (active radars).
If the input has the contact close the door works in night mode (disactive radars).
The operation of the closing safety sensor EC2 must be enabled by dip-switch 1 of S2 = ON.
If during closing it detects
the presence of an obstacle, the door stops and reopens.
If during pause it detects the presence of an obstacle, the door remains open.
• TERMINAL BOARD M3 (Inputs 13, 14, 15, 16)
13 = Input Common
14 = AUX1. Input of closing safety sensor E.C.2; N.C. contact.
15 = AUX2. Input of opening safety sensor E.O.2, N.C. contact.
The operation of the opening safety sensor E.O.2 must be enabled by dip-switch 2 of S2 = ON.
The door opens at slow speed if the sensor detects an obstacle during opening.
The door stops 200 mm from the end of the opening if the opening safety sensor is actived.
24
To Next Page
Loading...
Need help?
General
