13) FUNCTIONS and POTENTIOMETERS
DIP-SWITCH AND POTENTIOMETERS SETTINGS
Carefully read this paragraph to learn how to adjust the dip-switch S1, S2 and
potentiometers from TM1 to TM6.
After changing the dip-switch and potentiometers settings make sure to confirm through
the "PS3 FUNCTION" red button in the following way:
1. Set the function on the dip switch or the value on the potentiometer (these parameters
can be changed simultaneously).
2. Press and hold the "PS3 FUNCTION" red button for about 2 seconds until the buzzer
emits two short beep tones and then immediately release the PS3 button.
3. Press again "within 2 seconds" the "PS3 FUNCTION" red button, the buzzer will emit
four short beep tones to signal the new settings acquired.
PS3
FUNCTION
RELEASE
PS3
PRESS and HOLD
2 short beeps
within 2 seconds max.
PS3
FUNCTION
PRESS
RELEASE
PS3
4 short beeps
SEQUENCE of STEPS DESCRIBED IN POINTS 2 - 3
26
To Next Page
Loading...
