15) BATTERY-POWERED EMERGENCY OPENING DEVICE ET-BAT90
Assembly of the battery unit on the et-drive module
The battery containment plate is mounted on the back of the
module ET-DRIVE/90 using the hexagon socket head cap screws
4x6.
A
B
C
D
Remove the container of the electronic control unit by unscrewing
the two screws M5x10.
Position the battery inside the plate.
Refit the container of the electronic control unit inserting the battery
cable through the slot at the top and tighten the screws M5x10.
To replace the battery, perform the operations described in steps B, C and D.
30
To Next Page
Loading...
