C. MANUAL ALTERNATING MODE:
Mode suitable for worksites requiring dynamic alternating lanes. The user manually operates the alternating system by
giving the green light or red light from the remote control. As PTLs are interconnected by radio, giving the green light to
traffic from one direction means that the PTL for the other direction will automatically switch to red. An All Red phase can
also be simulated from the remote control.
Mode reserved for systems comprising 2 paired PTLs and worksites with perfect visibility of all traffic. To further enhance
safety when using this mode, LACROIX City recommends using flashing beacons, which are sold separately.
CYCLES BEGIN IMMEDIATELY FOLLOWING MODE SELECTION.
D. FLASHING YELLOW MODE:
This mode activates the flashing yellow on the central lens, mode used when the traffic no longer requires an alternating
traffic flow system to be implemented. The mode is also automatically activated on all currently operating system lights in
the following situations:
- Battery life < 12 hrs
- Battery disconnected from the PTL during use
- Radio fault (if modes Standard + Worksite Exit, Automatic Regulation, Green on Detection are active)
- Red lens fault (> 50% of the lens is faulty)
- PTL moved/fallen
Mode does not require any programming from the user.
CYCLES BEGIN IMMEDIATELY FOLLOWING MODE SELECTION.
To Next Page
Loading...