6. PAIRING
The lights and the remote control are equipped with radios that enable them to communicate to provide enhanced worksite
safety. The radio, which is embedded in the remote control, allows it to communicate remotely with the lights deployed,
monitor them and receive remote alerts.
The pairing phase makes it possible to group individual lights and the remote control together into a unit called a “system”.
A system can contain a maximum of 4 lights and 3 remote controls.
Lights are paired using infrared, the infrared signal window is located on the back of each light-head. The remote control
should be positioned a few centimetres away and opposite the infrared signal window.
During pairing, the ID of each light is indicated on the central lens for simplified deployment:
ENSURE THAT THE LIGHTS TO BE PAIRED ARE POWERED BEFORE BEGINNING THE PAIRING PHASE.
IF THE REMOTE CONTROL GOES INTO STANDBY MODE BEFORE PAIRING IS COMPLETE, THE PAIRING IS LOST.
ENSURE THE REMOTE CONTROL IS KEPT ACTIVE DURING THE PROCESS BY PRESSING THE BUTTONS ON THE LEFT
OR RIGHT. THE STANDBY TIME (1 MIN BY DEFAULT) CAN BE CHANGED FROM THE PARAMETERS MENU, REMOTE
CONTROL SETTINGS.
To Next Page
Loading...