HULL / DECK
23
2
HULL / DECK
The standard measurement "Zero" corresponds to the position of the
anchor ready to be dropped.
Refer to instructions for its use and maintenance.
n 2.8 Deckwash pump (optional extra)
The deck wash pump is located in the cupboard in the starboard front
cabin.
It provides sea water or fresh water from tanks.
The fresh or sea water selector valve is located in the fore peak
starboard locker.
Turn on the deck wash pump using its control located in the saloon
under the chart table.
l
ANCHORING
Have your boat head wind and without speed.
Pay out the chain while moving back slowly.
Secure the chain on the strop.
Release the chain until the strop is taut.
Pay attention to the swinging space when mooring.
l
LIFTING THE ANCHOR
Ensure that the chain is properly set on the gypsy.
Activate the windlass in the upward position.
Slowly go near the anchor using the engine (do not use the windlass
force to winch up the boat).
Visually check the final metres until the anchor makes contact with
the anchor roller.
Check the position of the anchor on the stemhead fitting.
Rinse the windlass and the ground tackle with fresh water after each
trip.
In case of electric failure, use the winch handle on the windlass to
raise the ground tackle.
Refer to the manufacturer’s instructions for windlass maintenance.
Nota: the boat may be optionally fitted with a chain counter in the
helm station.
The chainmeter box has a fitted windlass control.
LAGOON 39
WARNING
Windlass operations are dangerous:
- Always keep the ground takle clear and free.
- Always proceed with care, wearing gloves and
always wearing shoes.
- Make sure that nobody leans on the windlass when
operating the control.
To Next Page
Loading...
