38
9 Faults/Warnings
9.2 Warnings
Message by LED row, LED 7 to 12, LED 12 lights up.
Warnings (LED ON)
* Only relevant in conjunction with an integrated O
2
control system.
Without an integrated O
2
control system the dynamic test should remain OFF
parameter 1330 = 0.
Legend: LED
is off
flashes
lights up
12 11 10 9 8 7 Warning No.:
Display of active warnings (red),
LED(s) permanently on.
No warnings/faults active
1
Internal resistance too high
2
Offset voltage to air invalid
19
Analogue input 1: input value too
high/low
20
Analogue input 2: input value too
high/low
21
Analogue input 3: input value too
high/low
22
Analogue input 4: input value too
high/low
23
Configuration error analogue
output
24
Service warning 1
25
Service warning 2
26
No probe dynamics *
27
Dynamic test triggered *
To Next Page
Loading...
