Lamtec LT2 - 10 Spare Parts; LT2 Spare Parts; Spare Parts Lambda Probe LS2 in Housing

43
10 Spare Parts
10 Spare Parts
10.1 LT2 Spare Parts
The following is a list of relevant spare parts. It is recommended to maintain a stock of the
spares marked
(1)
.
Spares marked with the footnote
(2)
should be kept if considered appropriate.
Spares marked with the footnote
(3)
should be kept only if the system is equipped with the rel-
evant option.
10.2 Spare Parts Lambda Probe LS2 in Housing
Spare parts
Display and Operation Unit LT2 657R0833
(3)
1 Replacement main board for LT2, without connector set 657E1882
(2)
1 Processor electronic board for LT2 657R1874 LT2
(2)
1 Replacement power supply transformer for LT2 657P0342
(2)
1 Analogue output module 0/4 ... 20 mA; 0 ... 10 V 657R0050
(2)
1 Analogue output module0/4 ... 20 mA; 0 ... 10 V floating, Max. potential difference 20 V 657R0051
(3)
1 Analogue input module LT1/LT2 Potentiometer 1 ... 5  657P6000
(3)
1 Analogue input module 0/4 ... 20 mA 663P6001
(3)
1 Analogue input module 0/4 ... 20 mA with supply 24 VDC for transmitter 663P6002
(3)
1 Analogue input module 0/2 ... 10 V 657P6005
(3)
1 Temperature input for Pt100 657R0890
(3)
1 Temperature sensor Pt100, 250 mm (9.843" in) long 657R0891
(3)
1 Relay card for digital outputs, 6 relays, 1 switcher each 660R0017
(3)
Wear parts
1 LS2 Lambda Probe average lifetime ca. 10.000 - 20.000 operating hours (depending on fuel)
(without gas extraction device (GED))
650R1000
(1)
Spare parts
1 Gas extraction device (GED),e.g. 300 mm (11.81" in) long, for standard lengths see price lists
1 Gas extraction device (GED) 150 mm (5.91" in)
1 Gas extraction device (GED) 450 mm (17.72" in)
1 Gas extraction device (GED) 1000 mm (39.37" in)
655R1002
(3)
655R1001
(3)
655R1003
(3)
655R1004
(3)
1 Anti-size-paste (package of 5) 650R1090
(1)
1 Probe installation fitting (PIF) 655R1010
(1)
1 Clamping ring for PIF655R1010 (package of 5) 650R1013
(1)
(1)
Recommendation: Add these spare parts into stock