Lancom GS-1224 - Page 41

LANCOM GS-1224
쮿 Chapter 4: Operation of Web- based Management
40
EN
Configuration
The 802.1X Server Configuration is used to configure the global parameters
for RADIUS authentication in 802.1X port security application.
Parameter:
쮿 Mode:
Enable or disable 802.1X function.
쮿 RADIUS IP:
RADIUS server IP address for authentication.
Default: 0.0.0.0
쮿 RADIUS UDP Port:
The port number to communicate with RADIUS server for the authentica-
tion service. The valid value ranges 1-65535.
Default port number is 1812.
쮿 RADIUS Secret:
The secret key between authentication server and authenticator. It is a
string with the length 1 - 15 characters. The character string may contain
upper case, lower case and 0-9. It is character sense. It is not allowed to
put a blank between any two characters.
Default: None
쮿 Admin State:
This is used to set the operation mode of authorization. There are three
type of operation mode supported: Force Unauthorized, Force Authorized,
Auto.
왏 Force Unauthorized:
The controlled port is forced to hold in the unauthorized state, no
matter which EAP negotiation between authenticator and supplicant
takes place.
Multihost Auto Failure Port Unauthorized
Multihost ForceUnauthorized Don’t Care Port Unauthorized
Multihost ForceAuthorized Don’t Care Port Authorized