NMS045 Reference Manual Measurement Setup A-10
defining trigger and exceedance levels, see section 6.2.6 in the SLM
Model 831C Reference Manual.
Other alerts, such as an Intrusion Detection alert are available through
the RV50X. For more information about setting up this alert, see 2.5.3
"Configuring the Intrusion Detection" on page 2-7.
To set up an exceedance alert notification, follow these steps:
Step 1 Connect the 831C to a router with Internet access via WiFi or TCP.
Step 2 Create an Event History Setup File with an alert as described in section
17.3.1 of the SLM Model 831C Reference Manual. Follow the directions in
that section to enable email alert notifications.
TRY THIS Use the process described here to set up an email or text alert when the
SPL 2 or Peak 3 Trigger exceeds the set threshold. Then Run a
measurement, and cause a trigger event. Observe the resulting email or
text with an attached sound recording.
A.6.1 Listening to OGG Files
The 831C supports interfacing with the meter using a browser. This
function is in beta testing, and the functionality is not complete.
Support for browsers and audio playback is summarized below:
A.7 Measurement Setup
To learn more about setting up a measurement, refer to Module 6:
Measurement Setup in the SLM Model 831C Reference Manual.
Table A.4 Audio Playback
Platform Browser Audio File (.OGG)
Windows Internet Explorer - Not
recommended
No Supported
Chrome - Recommended Supported
Firefox Not Tested
Microsoft Edge Not Tested
Mobile (Apple &
Android)
Chrome - Recommended Supported
Safari Requires CODEC download
and installation
Opera Not Tested
Symbian Not Tested
To Next Page
