LaserPro Mercury - Setup and Communication Parameters

M
M
M
E
E
E
R
R
R
C
C
C
U
U
U
R
R
R
Y
Y
Y
U
U
U
S
S
S
E
E
E
R
R
R
M
M
M
A
A
A
N
N
N
U
U
U
A
A
A
L
L
L
35
z Tune (Auto focusing)?
In case the focal length of auto Focus needs to be corrected, please insert the corresponding
manual focal tool to the hole of the holder shown as in the Figure of LENS and MANUAL
FOCUS GAUGE. Then, operate as follows.
Press arrow up/down key to tune
focusing position then press
ENTER
ENTER
Tune (Autofocusing)?
Yes: ENTER
End operation: ESC
Select setup #1-16? :
Press AUTO FOCUS key then
FUNCTION key
select the function
Tune (Autofocusing)
If you have not pressed
AUTO FOCUS after power
ON
If you have ever pressed
AUTO FOCUS after power
ON
Attach manual focus gauge to the
carriage and press arrow key up
and down to position the working
table in focus then press ENTER.
New focal length has been saved.
Complete tuning
Ready to setup or
send a file to
start a job
Select set up #1-16?
Yes: ENTER
End operation: ESC
Select baud rate? :