Laspaziale S8 DSP - Page 11

9
LSI 090 - Rev. 00 - Ed. 04/2018
Danger!
If it becomes necessary to replace the machine’s power supply cable, utilise only these types: CET ELECTRIC H07RN-F 5 x
2.5mm (400V) for 2/3 group versions, 5 x 4mm (400V) for 4 group versions - CET ELECTRIC SINGLE PHASE 3 x 2.5mm (220V)
2 group versions, 3 x 4mm (220V) for 3/4 group versions. Replacing the cable must be carried out by qualied personnel.
The electrical safety of the appliance is fully achieved only after it has been correctly connected to an earthing system as
required by the laws in force.
Danger!
The appliance must be supplied exclusively with cold drinking water. Maximum mains pressure (static pressure) must not be
higher than 0.6 MPa.
Danger!
If in doubt, concerning the above mentioned requirements (about the system previously installed by the customer), please
have them checked by qualied staff.
Danger!
The electrical safety of the appliance is fully achieved only after it has been correctly connected to an earthing system as
required by the laws in force.
Attention!
Installation must be carried out by qualied personnel according to current laws and to the manufacturer’s instructions.
Incorrect installation may cause damage to people, animals or property for which the manufacturer cannot be held liable.