27
LSI 090 - Rev. 00 - Ed. 04/2018
After conrming the setting, the program passes onto the settings for the softener
FILTER menu.
The display will show:
Where “Y” (Yes) will be ashing. To select “N” (No) press one of the 2 arrow keys
, “N” will start to ash. If you press the button , the control of the softe-
ner lter remains deactivated, quitting the programming function and returning to the
initial screen.
If you conrm with “Y”, pressing the button
, enables the control and allows the
setting of the number of softener litres, after which it is necessary to replace the lter.
The number decreases at every delivery operation. The display must read:
Where the rst “0” on the right is ashing. When the button
is pressed, this in-
creases the number (0 - 9), while pressing the button
, moves onto the most im-
portant digit on the left (the selected digit ashes to indicate that it can be changed).
Once the litre value has been set, conrm the setting by pressing the button
.
At this point it is possible to enter a minimum number of litres, after which the applian-
ce will display an alarm on the control panel (6) by switching on the relevant control
light. The display will read:
Fig. 17
Fig. 18
Fig. 19
To Next Page
Loading...
