28
LSI 090 - Rev. 00 - Ed. 04/2018
Where the rst “0” on the right is ashing. Pressing the button , will increase the
number (0 - 9), while pressing the button
, moves to the most important digit on
the left (the selected digit will ash to show that it can be changed). Once the litres
value has been set, conrm the setting by pressing the button
and it is possible
to quit the programming function.
Take note!
The number cannot be greater than or equal to the maximum number of sole-
noid valve cycles set previously.
With the controls enabled and the display connected, the display will show the remai-
ning number of cycles before it is necessary to proceed with maintenance
Or the number of litres remaining before the softener FILTER cartridge needs to be
replaced:
Fig. 20
Fig. 21
To Next Page
Loading...
