Initial Set-Up
Tires and Wheels
3
3-18 Lastec//061714 Initial Set-Up
6. Repeat the measuring technique on deck 2 and 4. The adjustment rods on both the
rocker and the rear wheels can be made in the same manner as the center deck adjust-
ment.
7. Level the outer decks, 1 and 5, last. Use the jam nuts on the adjustment rod to make
minor adjustments.
3.19 Tires and Wheels
Check the air pressure in the rear drive tires. Maintain air pressure at 18 psi, or as needed
to maintain level deck cutting.
Check the air pressure in the front tires. Maintain air pressure at 12 psi, or as needed to
maintain level deck cutting
Verify proper function of all mower deck wheels. The wheels should turn freely without
excessive side-to-side motion, and be free of debris. Clean, adjust, replace, and grease
as necessary.
Check that each wheel swivels freely in the shaft pivot collar, and the bearings are in
good condition. If any wheel does not swivel freely, clean and grease the shaft collar
assembly. Replace the bearings if necessary.
To Next Page
Loading...
