Lauda RP 890 User Manual

Proline Low-temperature Thermostats
34 Starting up YACE0072 / 21.08.07
7.5 "Master" menu structure
1%21
Actual bath temperature
or actual value of
external temperature
Section 7.6.1
RDr Set setpoint
Section 7.7.1
Os Pump power
Section 7.7.3
Bml Control Int/Ext
Section 7.7.4
LMDkt Settings
Section 7.6.2
LMnet Conf. Modules
Section 7.6.3
RDB Protection system
Section 7.6.9
B/LM Command
Section 7.6.3
B//l Cooling system
Section 7.6.10
@l@ Analog module
Section 8.4
pR Conf. RS232/ 485
Section 8.3
c0a Conf. digit. mod.
Section 8.5
O@pA- Parameters
Section 7.6.4
O0c-- Control par.
Only internal or external
parameters are offered
depending on control
variable
Section 7.6.5 / 7.6.6
RgmY[ Show values
Section 7.6.8
B@K-- Pt100 calibration
Section 7.6.7
B@K 0 Offset int. Pt100
Section 7.8.7
cDE ! Works settgs. int. Pt
Section 7.8.8
B@K D Offset ext. Pt100
Section 0
cDE D Works settgs. ext. Pt
Section 7.8.10
TDp Software version
Section 9.2.2
Rlp^G Serial number Hi Word.
Section 9.2.3
Rlp^K Serial number Lo Word.
Section 9.2.3
RrDKK Control value of tempera.
controller. Section 9.2.4
rGD@c Temp. of housing °C
Section 9.2.4
rGR Temp. of heatsink °C
Section 9.2.4
E@l T Fan voltage in V.
Section 9.2.4
0DEE Mains curr. consumpt. in A
Section 9.2.4
T^RDB Prot. syst. voltage in V.
Section 9.2.4
T13 Act. val. 24V voltage in V.
Section 9.2.4
OT 0 Current consumpt. pump I.
Section 9.2.4
OT O Power consumpt. pump W
Section 9.2.4
OT l Pump speed rpm.
Section 9.2.4
lE 4/ Mains frequency Hz
Section 9.2.4
lT Mains volt. % of rated volt.
Section 9.2.4
KD Bath level [cm]
Section 9.2.4
rD Or Extern temp. Pt100
Section 9.2.4
rD@l@ Ext. temp. analog. interf.
Section 9.2.4
rDRDp Ext.temp. RS232/485
Section 9.2.4
hRDr Curr. controller setpoint.
Section 9.2.4
RDro- Setpoint relat. to act.
val. Section 7.8.4
R Setpoint resolution
Section 7.8.1
Rr@pr Opern. w. mains fail.
Section 7.8.2
rhg Upper temp. limit
Section 7.8.3
Bsp Max. current consumpt.
Section 7.7.5
rhK Lower temp. limit
Section 7.8.3
rXOF- Detect type of unit.
Section 9.2.1
cDE Works setting
Section 7.8.5
@scin Signal settings.
Section 7.8.6
G^@ll Counter operating hours
Master complete
G^OT Counter operating hours
Pump
rc Int. damping time (Td)=
Section 7.13.1
^O Int. proport.range (Xp)
Section 7.13.1
rl Internal reset time (Tn)
Section 7.13.1
rs Int. derivative time (Tv)
Section 7.13.1
rsc Int. contr. par. auto/man.
Section 7.13.1
cDE Works settings
Section 7.13.1
hO External P-controller (Xpf)
Section 7.13.2
Dt Ext. derivative time (Tve)
Section 7.13.2
Dc Ext. damping time (Tde)
Section 7.13.2
Da Ext.propor.range (Prop_E)
Section 7.13.2
Dr/K Ext.correct. var. (K)
Section 7.13.2
D Ext. contr.par. auto/ man.
Section 7.13.2
cDE Works settings
Section 7.13.2
Dl External reset time (Tne)
Section 7.13.2
DO Ext. prop. factor (Kpe)
Section 7.13.2

Lauda RP 890 Specifications

General

Brand	Lauda
Model	RP 890
Category	Thermostat
Language	English