LAUNCH X-431 PRO3 User Manual
8
3 Preparations
3.1 Charging X-431 PRO3
There are two charging methods available:
Via Power adaptor:
1. Insert one end of the included USB cable into the power adaptor.
2. Connect the other end into the charging port of X-431 PRO3.
3. Plug the adaptor into AC outlet.
Via Personal computer:
1. Insert one end of the included USB cable into the USB port of PC.
2. Connect the other end into the charging port of X-431 PRO3.
If appears on the screen, it indicates it is being charged. If the logo changes
into , it indicates that the battery is fully charged. Unplug the USB cable on the
charger from X-431 PRO3.
3.2 Using your battery
If the battery remains unused for a long period of time or the battery is
completely discharged, it is normal that the tool will not power on while being
charged. Please charge it for a period of 5 minutes and then turn it on.
Please use the included power adaptor to charge your tool. No responsibility
can be assumed for any damage or loss caused as a result of using power
adaptors other than the one supplied.
While X-431 PRO3 has low battery, a beep will sound. If it is very low, X-431
PRO3 will be switched off automatically.
3.3 Power on/off
3.3.1 Power on
Press [POWER] to turn the tool on.
*Note: If it is the first time you have used this tool or the tool remains idle for a long
period of time, the tool could fail to turn on. Please charge the tool for a minimum of 5
minutes and attempt to turn on again.
To Next Page
Loading...
